Got it printing pretty well over winter break!  In the beginning had trouble with layer shifts until I figured out a set screw was loose on my left motor- after that it was relatively minor fixes for stability.  I’ve been printing mostly ABS since me and PLA do not get along- below are my ABS (left) and PLA (right) benchys.  It is apparently possible to print ABS w/out enclosure if you use a ton of glue, also have been experimenting with the ‘enable draft shield’ option in Cura.  benchy.png

More prints (STLs available here: http://www.thingiverse.com/pinkbeetle/makes)dc5514c23e8427ce95b406c4f4d7c7e3_preview_featured.JPG

c270eb7dd0e8b6b2e46e7b8efb3a1362_preview_featured.jpg

c27d0e20846040b8a57121fa1d4a9573_preview_featured.jpg

91752d0c853870bd0eb59a090c94b130_preview_featured.jpg

8118120b6c84536445bb29f50acf0963_preview_featured.jpgc27d0e20846040b8a57121fa1d4a9573_preview_featured-1.jpg

unnamed-5.jpg

unnamed-4.jpg

^Quite a bit better then my first prints!:IMG_8062.JPG